Wishbone Suspension Lever Tool Bottom Control Arm 1.2m B6104

Sliding adjustment for easy positioning.

To push down the wishbone and other suspension parts, e.g. during the disassembly of the drive shaft, during replacing the gaiter or exchange of the wheel bearing.

After loosening the ball joint the wishbone must, in most cases, be pushed down against the bush or stabiliser tension in order to pull the joint from the support.
Very often it's here where problems arise:

- the joint wedges again in the cone after it was pressed down only briefly with a tyre lever
- the ball joint or gaiter gets damaged
- the mechanic injures himself or damages suspension parts when the tyre lever slips away

With this lever tool the work can be accomplished safely and comfortably by one person.

Length: 1170mm


Collections: Bergen Under Car Tools

Category: Under Car

Type: Bergen Under Car

Brands: Bergen


Pin It Fancy

Related Items

18pc BRAKE CALIPER PISTON WIND-BACK TOOL KIT Set
18pc BRAKE CALIPER PISTON WIND-BACK TOOL KIT Set £31.95 - Sold Out
Quick Shop
5pc Coil Spring Compressor for Mercedes Benz remove in- situ, Saves Time B6200
5pc Coil Spring Compressor for Mercedes Benz remove in- situ, Saves Time B6200 £94.95
Quick Shop
BERGEN 5pc Tie Rod Spreader / Ball Joint  Separator Pit Arm Wedge Set Air Hammer
BERGEN 5pc Tie Rod Spreader / Ball Joint Separator Pit Arm Wedge Set Air Hammer £21.50
Quick Shop
Bergen Professional Digital Depth Gauge 0 - 25.4mm B5016
Bergen Professional Digital Depth Gauge 0 - 25.4mm B5016 £7.25
Quick Shop